Developing Low Cost Eco-friendly Restoration Mortars for Historic Lime-based Stucco and Building Materials
Abstract
In this work, three formulations based on hydrated lime and eco-friendly additives of powdered brick, fly ash and silica fume were designed to improve repair mortars for historic lime-based stucco and building materials. The microscopic features, physical-mechanical behavior and the microstructure of the prepared mortars were evaluated before and after artificial ageing (by humidity/drying cycles and salt weathering). However, a significant mechanical enhancement was reported for the studied mixes, but the silica fume mix showed a notable failure after salt ageing. The fly ash mix revealed the highest bulk density ratio (1.172 g/cm3) compared to the lime and silica fume mixes. The silica fume mix recorded the lowest percentage of water absorption (35.56%) and apparent porosity (28.11%). Further, the silica fume mix yielded the highest dry compressive strength value (22.19 kg/cm2), with an increase reached 31% when compared to the standard lime mix. The results demonstrated that the fly ash mortar is more compatible for sustainable restoration procedures of historic lime-based structures in respect of the physical-mechanical properties.
Keywords:
historic lime-based stucco, eco-friendly repair mortars, FE-SEM, compressive strength, salt ageingPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

