Bond of Reinforcement with Normal-weight Fiber Reinforced Concrete
Abstract
In reinforced concrete members, upon loading, tensile stresses from reinforcement to concrete transfer via bond. Proper bond between the two material guarantees safety of such members. This paper presents test results performed on Pull-out specimens for evaluation and comparison of bond strength behavior of Normal-weight Fiber Reinforced Concrete (NWFC). Test parameters included reinforcement size and fiber content. Three different reinforcement sizes (10, 16 and 20 mm) and four concrete mixes having fiber contents of 0, 20, 40 and 60 kg/m3 were used for current experimental work. In total, 36 Pull-out specimens were tested; although the size of specimens varied with reinforcement size, concrete cover to bar diameter ratio (c/db) remained constant. From the selected range of fiber content used in current experimental work, dosage of 40 kg/m3 was found to have positive effect on most of the concrete properties. Test results indicate decrease in ultimate bond strength with increasing bar size. The effect of fibers was not observed in enhancing the pre-crack performance of the test specimens, whereas the ultimate bond strength and post peak bond strength performance increased significantly. The ultimate bond strength is found to be strongly affected by the compressive strength rather than fiber volume.
Keywords:
Concrete, Pull-out, Bond, Fibers, Hooked-endPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

