A New Approach for Measurement of Tensile Strength of Concrete
Abstract
Tensile strength is one of the important mechanical properties of concrete. Indirect methods have been used up till now for its measurement. These methods though widely accepted, do not furnish the true tensile strength of concrete. In this paper, a compression to tensile load transformer device is developed to determine direct tensile strength of concrete. The cubic concrete samples with dimension of 15*19*6 cm containing internal hole with dimension of 75mm is prepared using the mixture of cement, fine sand and water. This model is subjected to direct tensile loading by special loading device. A series of finite element analysis were performed using FRANC2D to analyse the effect of hole diameter on the stress concentration around the hole and to render a suitable criteria for determination of real tensile strength of concrete. Concurrent with direct tensile test, Brazilian test is performed to compare the results of two methods. Results obtained by this test are quite encouraging and shows that the direct tensile strength is clearly lower than the Brazilian test. The dierence between the Brazilian and direct tensile strengths is about 33%.
Keywords:
Compression to tensile load converter, tensile strength of concrete, FRANC2DPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

