Properties of Foundry Sand, Ground Granulated Blast Furnace Slag and Bottom Ash Based Geopolymers under Ambient Conditions
Abstract
This paper presents a feasibility study on the manufacture of geopolymer concrete at low concentrations of alkaline solutions and lower densities and incorporating waste products like Foundry sand without compensating for the strength properties. Ground Granulated Blast Furnace Slag (GGBFS) and Bottom ash (BA) were used as source materials. From the preliminary studies, the replacement of Foundry sand to Natural sand is taken as 50:50. The density range was taken as 1800 Kg/m3, 2000 Kg/m3, 2200 Kg/m3 and 2400 Kg/m3. Sodium Hydroxide(NaOH) and Sodium Silicate(Na2SiO3) were used as alkaline activators and the molarity of NaOH solution was reduced from 8M upto 4 M. The percentage ratio of BA-GGBFS was selected as 0, 25, 50, 75 and 100. The ratio of Alkaline liquid to Binder content was taken as 0.4 and the molar ratio of NaOH solution was kept as 1. The ratio of Sodium silicate solution to Sodium hydroxide was taken as 2. Ambient curing was adopted for all the mixes. The properties of Geopolymer concrete paver blocks such as Compressive strength, flexural strength and split tensile strength, water absorption, Acid attack and Water absorption were conducted as per IS 15658:2006. Test results show that satisfactory strength properties of geopolymer concrete using Foundry sand can be achieved even with lower concentrations of NaOH solution under ambient curing conditions. This would pave way for creating a greener environment by the efficient use of byproducts and waste materials in concrete.
Keywords:
ground bottom ash, curing, molarity, molar ratio, compressive strengthPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

