THE EFFECT OF THE CEMENT TYPE AND OF CURING ON THE MASS AND DEFORMATIONS OF HARDENED CEMENT PASTE
Abstract
We have prepared test cylinders out of three cements significantly different in composition (clean portland cement, cement with 40% blast furnace slag content and cement with 20% fly ash content) changing the water/cement ratio (0.10, 0.15, 0.20) and the stamping force (5, 15, 50, 100 N/mm2). The cylinders were cured under different conditions (air of 50-60% or 95% relative humidity or in lime saturated water), examined the change in length and the mass of them by time and determined their strength at the age of 90 days. Out of the three cement types - stamped under the same conditions - the cylinders with fly ash content had the biggest porosity. The curing method has significantly influenced the change of porosity, mass and deformation of the cylinders by time. The effect of cement type has shown on one hand in porosity and on the other hand especially in the initial deformations of the cylinders the physical and chemical processes during setting (e.g. formation of ettringite).
Keywords:
cements, porosity, climatic effects, specific deformationsHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

