Determining the Stress Pattern in the HH Railroad Ties due to Dynamic Loads
Abstract
This paper deals with the determination of the stress propagation in the HH10 type of steel railroad ties under dynamic loads. The HH10 type of steel ties were tested for fatigue at the University of Illinois at Urbana-Champaign. Simultaneously with the laboratory fatigue tests, I was modelling the stress distribution in the tie due to the dynamic loads with using finite-element software `ABAQUS´. After the introduction, the laboratory arrangement of the tie fatigue test will described in Chapter 2. Chapter 3 details the steps in building up the finite-element model of the `HH´ railroad ties. In Chapter 4, the stress pattern and numerical values for the stresses and displacements of the tie due to dynamic loads as results of the finite-element program will be presented. The most important results will be summarized in Chapter 5.
Keywords:
railroad ties, sleepersHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

