FOUNDATION STRENGTHENING AND GROUTING BY MEANS OF JET PILES FOR A 9+1-STOREY BUILDING WITH STRENGTHENED-CONCRETE FRAMING
Abstract
The reinforced concrete frame building on the area of 17 x 150 sq.m consists of a cellar, ground floor and 9+1 storeys. The pillars were founded on solitary reinforced concrete blocks. The given vertical supporting system is horizontally connected by flexible, reinforced concrete sheets for ceiling. This configuration was not adequate to withstand, or balance the ensued uneven settlements arisen by the response of the alternating subsoil under the different loads from the pillars. At frames 14. to 27., however, - which were founded on weak silty fine sand of varying thickness (0.5 to 3.0 m) - the safety factor against failure was calculated to n=1, instead of n=2.77 that had to be prescribed. The goal was to transfer the loads from the silty fine sand onto the Kiscelli clay, which has excellent bearing capacity at 5 to 6 m deeper levels. The first part of the reading to be presented deals with the unavoidable geotechnical exploration, laboratory testing, determination of the intermittent and final time dependent parameters of the jet-propulsion work, the evaluation of the in situ bearing capacity trials and, of the strength analysis of the undisturbed samples having been taken from the jet piles. The second section informs about the design and accomplishment of the work, and concludes with the settlement monitoring results that verified the success. The measurements proved that the settlements stopped at the prescribed limits and, the reckoned safety factors against failure widely surpass the n=2.77 value required by the standard for this case.
Keywords:
foundation strengthening, jet pilesHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

