SHEARING TESTS WITH CONTINUOUSLY INCREASING NORMAL STRESS
Abstract
In the conventional shearing tests the normal force or the normal stiffness are kept constant during the experiment. Sliding under constant normal load occurs in slopes if the environment is not changing during the process. The goal of this paper is to investigate the influence of the continuously changing (i.e. increasing) normal load for the continuously increasing shearing load. Cement mortar specimens with triangular teeth that have the same inclination (regular triangular teeth) were used to carry out this research. Both the geometry of the specimens and the mechanical constants were well-known. The `Continuous Failure State` (CFS) shear tests were carried out according to CFS-triaxial tests, with different starting normal stresses. According to the investigations, the behaviour of the material in case of CFS-shearing tests was always different as in case of CFS-triaxial tests. Linear and nonlinear theoretical models are proposed for the measured curves.
Keywords:
shearing test, continuous failure state, slidingHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

