Conversion between static and dynamic load bearing capacity moduli and introduction of dynamic target values
Abstract
Two types of Light Falling Weight Deflectometers (LFWD) are in use in Hungary: the German device (Zorn, HMP and Wemex) and the new B \rm & C small-plate device, which was developed by Andreas Ltd. Both devices are able to measure the dynamic load bearing capacity of subgrades, subsoils, embankment layers and backfills. Extensive application of these apparatus still has not been achieved since the dynamic modulus is not accepted in the quality assessment and quality control process of embankments and subgrade layers. Only marginal use of these devices can be noticed, mainly on areas of low importance (e.g. road shoulders) or trenches where performing a static plate load test could be complicated. For being able to use these dynamic devices on embankment layers, research for converting the measured dynamic modulus into static modulus has been initiated. First results of this research are presented in this paper. Using international and Hungarian measurement results, required target values for E_vd and E_d have been proposed for implementation.
Keywords:
Light Drop-weight Tester, Light Falling Weight Deflectometer, B \rm, C, subgrade modulus, static plate load test, target values, load bearing capacityHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

