FEM-based approach for the stability design of thin-walled members by using cFSM base functions
Abstract
This paper presents a new design approach for the stability design of thin-walled members. The proposed approach is based on the buckling modes and critical forces/moments determined by a linear buckling analysis performed on a regular shell finite element model. A fully automatic buckling mode identification technique is applied, by using the modal base functions of the newly proposed constrained finite strip method, where the various buckling types are separated by clearly defined mechanical criteria. The paper briefly summarizes the determination of modal base functions which then are used to approximate finite element displacement functions (i.e., buckling modes). The mode identification method provides the lowest critical values (forces or moments) to all the three characteristic buckling types: global, distortional and local, on the basis of which the buckling resistance can be calculated by using the design formulae of the direct strength method. The proposed new approach, which is potentially more general than any of the existing design approaches, is demonstrated on Z columns and beams with simple loading and boundary conditions. Critical values as well as resistances are calculated for some selected cases, the results are compared to those of another design method. The comparisons prove the applicability of the proposed procedure. Further research is necessary to extend the proposal for more general and more complex practical cases.
Keywords:
Design of thin-walled members, Buckling modes, Finite element methodHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

