Effect of heating on the physical properties of asphalt aggregates
Abstract
Asphalt is defined as a mixture of inert mineral matter, such as aggregate, mineral filler and bituminous binder in predeterminated portions. One of the most important properties of asphalt mixtures is the bitumen content. The most preferred way of asphalt binder analysis is extraction (with tricloroethylene). Because of environmental reasons extraction should be replaced with more environment friendly solution, this could be heating. But high temperatures can cause changes in the physical properties of mineral aggregates that are commonly used in asphalt mixtures causing faults in the results of the binder analysis. Eight different types (five andesites, one basalt, two dolomites) of Hungarian rocks have been tested in laboratory conditions to analyse the effect of heat on asphalt aggregates. 11/16 mm fractions were heated at 480o C in an ignition furnace. The weight losses and grain distributions were recorded and compared. The physical parameters have shown that aggregates behave differently after burning on high temperature. As an additional result coloures and colour differences of aggregates were also observed after heating.
Keywords:
asphalt aggregates, physical properties, ignition furnace, weight loss, grain distributionHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

