Laboratory and virtual experiments on C-section compression members with semi-rigid connections
Abstract
In this paper results of an ongoing research on cold-formed C-section members are presented. The research aims the development of design methods for structural arrangements directly not covered by the standard, based on laboratory tests and numerical modelling. In the paper laboratory tests on C-section compression members are presented: arrangement, behaviour modes and load-bearing capacities. The behaviour of the specimens as well as the effect of the non-rigid end support provided by the self-drilling screws used to introduce load in the specimens are discussed. A numerical model capable of geometrically and materially nonlinear, imperfect analysis to reproduce the tests is introduced with a focus on the modelling of the connector elements and imperfections. An approach to model self-drilling screws and equivalent geometrical imperfections is presented; the applicability of the model is shown. It is shown, that screw stiffness and geometrical imperfections both influence the stiffness of the models. The ca libration of the model is carried out using the results of the experimental tests introduced previously; the results of these virtual experiments are presented.
Keywords:
cold-formed section, laboratory test, semi-rigid connection, self-drilling screw, geometrical imperfections, connection rigidity, numerical modelHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

