Effects influencing the compressive strength of a solid, fired clay brick
Abstract
The aim of the paper was to analyze the effect of the different influencing factors on the compressive strength of a solid, clay brick. The effect of the surface polishing, the height, width and length of the specimens, the type of the sampling (drilled or cut) and the effect of the production technology were studied. Though being the moisture content of the specimen an important factor, it was not examined herein. More than 110 brick specimens were tested using two different types of measuring procedures: standard (destructive) compressive tests and Schmidt hammer (non-destructive) tests were carried out. Formulae were proposed for determining the normalized mean compressive strength from every possible type of specimens that were adequate for testing in case of this type of unit. It was found that the behaviour of the brick is orthotropic. It was proved that the effect of the height of the specimen has the most significant effect on the compressive strength. A linear relationship was found between the norma lized mean compressive strength and the Young´s modulus of the brick in each direction.
Keywords:
solid clay brick, compressive strength, experimental investigation, size effect, Young´s modulusHow to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

