Effect of Coconut Fiber Content on the Properties of Unfired Building Bricks Incorporating Thermal Power Plant Ashes
Abstract
This study examined the effect of coconut fiber (CF) content on the properties of unfired building bricks (UBBs) using fly ash (FA) and bottom ash (BA) from the Nghi Son coal-fired thermal power plant (CTP). Cement and FA served as binders while BA replaced crushed stone as the fine aggregate. Raw brown CFs were treated with a 5% NaOH solution at 50 °C to increase their mechanical properties. The treated CFs were then cut to a short length of 15 mm and had an average aspect ratio of 103. Brick samples were cast with CF content at ratios of 0%, 3%, 6%, and 9% by binder weight (CF/B) and water-to-binder (W/B) ratios of 0.30 and 0.35. The UBBs were formed under a low pressure of 0.5 MPa and tested to evaluate the effects of CF/B and W/B ratios on brick properties. Results showed that compressive strength (CS) increased with higher CF content, with all samples exceeding 10 MPa after 28 days, classifying them as grade M10 per TCVN 6477:2016. The optimal CF content was 6%, which yielded the highest CS. Increasing CF content reduced unit weight (UW), ultrasonic pulse velocity (UPV), and thermal conductivity (TC), while water absorption (WA) increased. Conversely, a lower W/B ratio improved CS, UW, UPV, and TC, while reducing WA. Microstructural observations revealed that CF acts as a bridge connecting cracks, which helps restrain crack widening and enhance CS.
Keywords:
coconut fiber, unfired building brick, fly ash, bottom ash, thermal power plant ashesPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

