TESTING ASPHALTS FOR SPECIAL EXPOSURES
Abstract
Airfield runways are generally made using cement concrete pavements, prone to be renewed by asphalt concrete layers, but sometimes the pavement has to meet special requirements. The Department of Highway Engineering and the Institute of Thermal and Systems Engineering, TUB, cooperated in testing such special requirements. At first, heating and cooling caused by an airplane with low-mounted jet engine, applying an important heat load in preparing to take off, had been determined in field test, by means of an IR camera. Thereafter two asphalt mixes have been laboratory tested by applying 100 cycles of in-situ, thermal effects. One was a conventional AB-20 type mix, the other a highly deformation resistant plastic asphalt. Asphalt changes after heat loads have been determined in bending fatigue tests. The particularly high thermal effects were found not to be endured even by plastic asphalt mixes. On the other hand, impacts due to common airplanes are supported by conventional asphalts. Plastic asphalts have much lower bending fatigue lives, at higher building costs than for conventional asphalts. So construction of this kind of pavements would be meaningless. While alteration of operating conditions of airplanes imposing excessive heat loads would permit the use of asphalt concrete pavements in airfields.
Keywords:
rolled asphalt runway, thermal effects on asphalt, plastic asphalt, bending fatigue tests, asphalt pavement thermometry.How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

