Calibration of Hypoplastic Parameters – Two Different Aspects
Abstract
Numerical modeling serves as a widely utilized method for addressing geotechnical concerns. A pivotal aspect of this modeling process is the accurate characterization of material behavior. The connection between stress and strain tensors within soil is explicated by the soil constitutive equation, which is reliant on factors like soil type and deformation circumstances. One notable model is hypoplasticity, which has been in use for more than three decades. This research aims to calibrate the hypoplastic parameters for Danube sand using the SoilTest Module of PLAXIS. The constitutive hypoplastic model for Danube sand was fine-tuned through a series of numerical simulations. The parameter calibration occurred twice: initially according to 5 cycles of hysteresis loop of stress–strain diagram of cyclic triaxial testing, and then subsequently in accordance with strain trends observed after ten thousand cycles. A comparison was drawn between parameters determined from the overall strain trends and those calibrated based on the five cycles. The findings indicate that while the model calibrated during a specific segment of testing can accurately predict strain values during compression and extension, it falls short in forecasting the accumulated settlement following prolonged cyclic loading. This suggests the model’s limited capability in anticipating long-term cyclic load effects on settlement behavior.
Keywords:
hypoplasticity, intergranular strain, cyclic triaxial test, Danube sand, SoilTest ModulePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

