A Modified Reactive Powder Concrete Made with Fly Ash and River Sand: An Assessment on Engineering Properties and Microstructure
Abstract
Containing a high quantity of both fine powders and steel fiber makes reactive powder concrete (RPC) a unique kind of ultra-high strength concrete. However, the cost of manufacture, shrinkage, and hydration heat are increased when silica fume and cement are used in significant amounts. To mitigate these negative consequences and the environmental impact, this study assessed the use of fly ash (FA) with high volume combined with natural-fine river sand (NFRS) in the manufacturing of RPC. FA was utilized to partially substitute cement at 0, 20, 40, and 60 wt% in RPC mixtures that had a set water/binder ratio of 0.2. Thermal conductivity, porosity, water absorption, and compressive strength tests were performed. Furthermore, RPC's microstructure was examined using a scanning electron microscope (SEM). This study also included a cost and global warming potential analysis of RPC production. Test results indicated that a modified RPC with a 60 MPa compressive strength value could be created by using NFRS and a large amount of FA. In comparison to the reference mixture, a higher compressive strength, reduced water absorption, and lesser porosity were observed in RPC when the FA replacement amount was less than 40%. Many FA particles did not engage in the hydration reaction when the FA replacement level was more than 40%, which had a detrimental impact on the RPC's characteristics. In general, using FA to produce RPC has certain benefits for the economy and the environment. It is recommended that 40% of FA be used in actual practice.
Keywords:
fly ash, reactive powder concrete, river sand, global warming potential, production cost, microstructurePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

