Assessing the Equivalent Spring Method for Modelling of Lightweight-concrete Encased Cold-formed Steel Elements in Compression
Abstract
Using concrete for filling and bracing is one of the most crucial ways to improve cold-formed steel (CFS) elements' stability behavior and performance. An example is the novel building system made up by CFS encased in ultra-lightweight concrete. The numerical analysis of such structural members using solid finite elements is time-consuming, thus the need for an easy-to-use modelling technique has arisen. As a result, a simple time-efficient equivalent spring model (ESM) has been introduced as a viable method for properly analyzing complex structural behavior in numerous cases, replacing the concrete solid with one-directional springs applying the Winkler foundation. This study aims to examine the validity and limitations of the ESM by comparing it to 3D solid model (SMOD) results for internal plate elements. The analysis results indicate that the ESM could provide accurate results in the b/t range of 100 or less for a wide range of PAC modulus (50–250 MPa) with an error of less than 5%; hence, using spring in modelling PAC within these limits is deemed acceptable. Nevertheless, for larger b/t values up to 175, doubled the calculated spring stiffness is highly recommended. In addition, the results reveal that the applicability of ESM is limited for b/t above 175; the model fails to predict the ultimate failure load, and the failure mode. Finally, this study ends by recommending one equation for calculating equivalent foundation spring stiffness for internal components that ensure optimal performance of the ESM analysis.
Keywords:
plate buckling, ultimate load bearing capacity, numerical analysis, simplified model, equivalent spring modelPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

