The Impact of Brick Powder Specific Surface Area on Cement Replacement in Mortar Mixes: A Sustainable and Cost-effective Solution for the Construction Industry
Abstract
This study examined the use of clay brick powder (CBP) as a partial substitute for cement in mortar mixes. Five mixes were tested, each differing by the fineness of the CBP, obtained by grinding brick waste for different durations (30, 60, 90, 120 minutes). Several parameters were evaluated; apparent density, porosity, spread, ultrasonic pulse velocity (UPV), flexural and compressive strength, and the pozzolanic activity index. The results indicate that, when the brick powder is ground for 60 minutes, the spread of the mortar exceeds 95% compared to the reference mortar. The addition of CBP appears to increase the water absorption and porosity of the mortars, without significantly influencing their apparent density. Most samples have a UPV close to 4000m/s, attesting to satisfactory mechanical properties. The use of 20% CBP in replacement of cement leads to a decrease in flexural strength. However, this drop is less when the specific surface area of the CBP is close to that of cement. As for compressive strength, a decrease is also noted with the introduction of CBP, but this decrease can be mitigated by using CBP with a specific surface area similar to that of cement. These factors can significantly influence the pozzolanic activity of the mortar mix. Furthermore, our investigations into environmental and economic analyses show that the use of cement mixes including CBP results in a significant decrease in energy consumption and CO2 emissions. More specifically, the replacement of 20% of cement with CBP of different granulometries has led to promising results.
Keywords:
clay brick powder, grinding time, ecological mortar, pozzolanic activity, specific surface, environmental impact, economic impactPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

