Effects of Tire Crumb Rubber and Steel Fiber on Punching Shear Behavior of Two-way Alkali-activated Concrete Flat Slabs
Abstract
As a result of the rapid increase in the demand for transportation vehicles recently, the accumulation of waste tires causes environmental problems. One of the methods that can contribute to the reduction of this environmental problem is the recycling of waste tires as a construction material in aggregate form. This research investigated the impacts of waste tire crumb rubber with/out steel fiber (SF) on the two-way punching-shear behavior alkali-activated concrete (AAC) flat slabs and performed center point load tests. In the study, one-type of SF and two kinds of scrap tire waste i.e., crumb rubber (CR) and tire particles, were used on the producing of rubberized AAC slabs obtained by 100% as binder made of ground-granulated blast furnace slag (GGBFS). Also, while both fine crumb rubber (FCR) and coarse crumb rubber (CCR) were used together in the AAC slabs, tire crumb rubber (TCR) was used alone at the same proportion. Additionally, the fine aggregate was substituted with 10% and 15% FCR and CCR, and coarse aggregate was substituted with TCR in the same proportions. Additionally, AAC slabs with recycled tire rubber (RTR) were produced as fibrous and non-fibrous using 1% by volume hook-end SF. In total, nine AAC slabs with sizes of 50 x 50 x 6 cm3 were manufactured for the study. Experimental data showed that the inclusion of RTR only slightly reduced the punching shear strength of AAC slabs and the punching shear strength of the slabs increased when SF was added to the mixtures containing RTR.
Keywords:
alkali-activated concrete, punching shear behavior, steel fiber, waste tire crumb rubberPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

