The Effect of Voids on Flexural Capacity of Reinforced Concrete Slabs
Abstract
The voided reinforced concrete slab system is mainly produced with polyester foam placed mostly at the bottom of the slab. The aim of the voids is to reduce the weight of the slab. In this paper behavior of the voided reinforced concrete slabs in which voids placed at the mid-height of the slab cross-section, is examined analytically. A series of models were created to come up with a lightweight slab. Two distinct slab models were analyzed using the ABAQUS software. In the first group, slabs had three layers, in which bottom and top layers were of solid reinforced concrete, but the mid layer was of voided unreinforced concrete. In the second layer, in order to increase the contact between top and bottom layers of the slab, crossties were utilized, and the mid layer was reinforced accordingly. Since all the layers were 5 cm thick, the total thickness of the slabs were 15 cm. Slabs were 100 cm wide and 200 cm long. They were simulated the three-point bending test. Concrete damaged plasticity material model (CDPM) for concrete and elastoplastic material model for steel was selected. From the results it was found that moment capacity decreased with the increase in the volume of the voids. There was a sudden decrease in strength after reaching the yield strength in voided slab without a crosstie. In addition, crossties enabled the reduction of the weight of the slabs without significant decrease in moment capacity.
Keywords:
composite slab, crosstie, flexural analysis, one-way slab, polystyrene foam, voided slabPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

