Effect of Static Loading States on the Compressional Behavior of Foam Glass Aggregate
Abstract
In this study, two groups of foam glass aggregate (FGA) samples were prepared with four different compaction ratios (10%, 20%, 30%, and 40%) and subjected to a series of static compressional loads from 50kPa to 300kPa with 50kPa interval. In first group of the test (changed load samples, ChLS), for each static load value, a new sample was prepared and tested. In the other group of the test (continuously loaded samples, CLS), all prescribed static compressional loads were sequentially applied over the same sample after satisfying the required strain rate at each load. The results revealed that the overall vertical strain values of CLS were lower than ChLS except for 10%, which shows reverse behavior. For both sample types, the required time to reach the desired vertical strain rate was much higher when the compaction ratio was low, and the compressional load was above 250 kPa. The compaction methodology used in the present study led to more reliable vertical strain values for both short- and long-term loading periods compared to other reported results executed on FGA under the same static compressional load circumstances. The evolution in the particle distribution curve of FGA particles after maximum compaction ratio (40%) was nonsignificant compared to the study works that depended on traditional standard test methods of compaction and led to severe change in particles structural component. The current findings beneficially affect civil engineering applications using FGA by defining the material's final strain values when subjected to static compressional loads at different compaction ratios.
Keywords:
compaction ratio, static compressional loads, vertical strain, strain ratePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

