Mechanical Properties of Gas Storage Sandstone under Uniaxial Cyclic Loading and Unloading Condition
Abstract
In order to study the mechanical properties and damage evolution of the gas storage surrounding rock under the periodic injection-production process, the uniaxial cyclic loading and unloading tests of sandstone were carried out by TFD-2000 microcomputer servo-controlled rock triaxial testing machine. Results shown that the compressive strength of gas storage sandstone specimens were gradually decreases with increasing of the stress amplitude after 200 cycles. The stress-strain curve under uniaxial cyclic loading and unloading condition formed hysteresis loops, and the hysteresis loop presented sparse-dense-sparse when the stress amplitude was relative higher. The residual strains can be divided into three stages of decay deformation stage, stable deformation stage and accelerated deformation stage when the stress amplitude is 8~32 MPa, this phenomenon is very similar to the creep behavior of rocks. The energy evolution of sandstone under cyclic loading and unloading was analyzed and the damage evolution low of which was also discussed in detail, the damage variable defined by energy dissipative ratio accumulation can well reflect the damage development of sandstone under uniaxial cyclic loading and unloading. A nonlinear visco-plastic body was proposed by considering the accelerate stage of curves of the axial residual strains, and used the nonlinear visco-plastic body to replace the visco-plastic body of the traditional Nishihara model, a nonlinear viscoelastic-plastic model for cyclic loads was established and the applicability of the model is verified. The research results provide certain reference value for the construction and maintenance of gas storage.
Keywords:
cyclic loading, energy evolution, energy dissipation, damage evolution, constitutive modelPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

