Impact of Failure-surface Parameters of Concrete Damage Plasticity Model on the Behavior of Reinforced Ultra-high Performance Concrete Beams
Abstract
The failure surface of elements can numerically represent by a concrete damage plasticity (CDP) model in Abaqus software which depends on five parameters. The parameters are eccentricity, shape, biaxial to uniaxial compressive strength ratio, dilation angle, and viscosity. This paper studies the effect of changing the values of the failure surface parameters on the bearing capacity, deflection, and overall structural behavior of ultra-high performance concrete (UHPC) beams. The parameters' changes include reasonable values higher or lower than the values adopted by Abaqus. An experimentally performed reinforced UHPC beam is simulated by Abaqus, and the five parameters are calibrated to coincide with the practical results. Then, one of the parameters is changed while others remain constant for each alteration to study its effect on the UHPC beam behavior. The numerical analysis results show that all five parameters do not affect the loading capacity and the corresponding deflection at the first cracking state. At peak state, the eccentricity does not affect the load and deflection. The influence of shape and the biaxial to uniaxial compressive strength ratio are confined to the deflection at peak load only without affecting the bearing capacity. The dilation angle effect appears when it is greater than 30 degrees to 56 degrees, while when it is less than 30, it does not affect the load and deflection. Rising the dilation angle and viscosity value promotes the peak load and the deflection.
Keywords:
Abaqus, concrete damage plasticity model, dilation angle, shape parameter, viscosity, eccentricityPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

