Cold Bonded and Low Temperature Sintered Artificial Aggregate Production by Using Waste Materials
Abstract
The paper presented the possibility of manufacturing aggregates from industrial waste materials and their ecological benefits. The cold bonding process to create aggregates uses substantially less energy than the sintering technique. This study deals with the outcomes of an experimental assessment of the physical and strength properties of environment-friendly cold-bonded and sintered fly ash (FA), ground granulated blast furnace slag (GGBFS), and quartz (Q) lightweight aggregates. The waste materials were mixed with Portland cement at 20–50 percent by weight to make artificial lightweight aggregates. To investigate the impacts of temperature on the physical properties, such as crushing strength, density, and water absorption, the pellets were sintered at 300, 600, and 900 °C for an hour. The results show that all the produced aggregates might be categorized as lightweight aggregates due to the combinations' average densities being less than 2,000 kg/m3. The fly ash lightweight aggregates had higher density and crushing strength, as well as decreased water absorption. The density and crushing strength improved somewhat by raising the temperature, while the water absorption decreased with increased temperature. In this research, the most efficient mineral admixture concentration has been evaluated as 50 percent for both fly ash and ground granulated blast furnace slag and 30 percent for quartz for cold-bonded pellets. Furthermore, superior physical qualities have been reported at the 900 °C sintering temperature.
Keywords:
fly ash, ground granulated blast furnace slag, quartz, lightweight artificial aggregate, recycling, waste materials, crushing strengthPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

