In-situ Primary Stress Detection Based on Seismic Tomography Measurements and Numerical Back-analysis for an Underground Radwaste Repository
Abstract
In order to understand how the in-situ primary stress state has evolved with subsidence and uplift in a granitic rock mass for anticipated of a radioactive waste repository in Hungary, the authors investigated the applicability of seismic tomography as an interpretive tool. Very high P wave velocity (Vp) values were obtained during the tomographic scanning of the study area of the repository, and these were compared with existing findings of in-situ and laboratory seismic measurements.
Apart from seismic tomographic survey, dynamic FEM numerical modelling, empirical calculations of residual stresses, laboratory measurements of compression wave (ultrasonic) velocities on intact rock cores, in-situ primary stress measurements as well as site geological model were integrated to evaluate the use of seismic tomography for identifying possible in-situ stress increases around the excavation.
A detailed calibration modelling was carried out based on the site seismic tomography measurements and during the large-scale modelling. It was observed that the increasing Vp is directly related to simulated increasing directional loadings on the rock mass. Using a measured wave raypath it was possible to check the different in-situ stress parametrizations which resulted in the best approximation to the measured Vp values.
It was concluded that the rock mass under investigation to extend the repository must have higher in-situ stress values than the area of the constructed deposition chambers nearby. The results of this research indicated that seismic tomography is a useful tool for determining relative stress around and within the vicinity of underground excavation.
Keywords:
in-situ stress, seismic tomography, dynamic modelling, wave velocity, raypathPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

