PFC Simulation Study on Time-dependent Deformation Failure Properties and Energy Conversion Law of Sandstone under Different Axial Stress
Abstract
Rock burst mostly happens in deep rock engineering, which obviously performs obvious time-dependent destruction and releases huge energy. Thus, the uniaxial compressive time-dependent deformation failure tests of sandstone under different axial stress are conducted and the optimized Parallel-bonded stress corrosion (PSC) model is established based on PFC method. The results show that tension micro-cracks are the direct reason of rock bearing capacity reduction during the whole failure process. The time-dependent deformation stage is composed of the initial strain stage, the steady-state strain stage and the accelerated strain stage. As the axial stress increases, rock mass enters into the accelerated strain stage more quickly and the strain amount of time-dependent deformation stage decreases. From the comparison of energy conversion between PFC simulation and experiments, the higher elastic strain energy will be accumulated and the less dissipation energy will be produced while the axial stress increases when reaching the failure point. After the failure point, the elastic strain energy has a small increase because the strain rate changes faster than the failure relaxation rate. Based on the calculation results of residual elastic energy index (AEF), the rock burst shows a tendency that from weakness to moderation as the axial stress increases. The research results will provide a certain reference in predicting the rock burst.
Keywords:
rock burst, time-dependent, PSC model, energy conversion, residual elastic energy indexPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

