Numerical Simulation of 3-D Internal Crack Propagation in Rock under Semi-circle Bending
Abstract
Semi-circle bending (SCB) test is an important test in the field of rock fracture. In order to investigate the propagation process of 3-D internal cracks under semi-circular bending, numerical simulations of SCB specimens were carried out based on the finite element method and adaptive mesh technique. The results show that the numerical simulation results of this method are in good agreement with the previous laboratory test. The symmetrical loading model belongs to the pure I loading where the value of KI is positively related to the bottom load span S/R. The asymmetric loading model belongs to mix-mode loading. With the increase of unilateral load span S2/R, there is a decline and then a rise of the value of SIF at the same point at the crack tip. The S2/R is an important factor affecting the mechanical properties of rock specimens. The crack propagation path was obtained based on the maximum tensile stress (MTS) criterion. In-plane propagation of the internal crack in the symmetrically loading model leads to failure of the specimen. Wing propagation of the internal crack in the asymmetrically loading model causes the specimen to fracture into two asymmetrical parts. Quantitative analysis of the internal crack propagation of the symmetrical loading model shows that the growth rate of the lower end of the crack is the largest, and the upper end of the crack is the smallest. The above results can provide a reference for the research on the propagation of 3-D internal cracks of SCB specimens.
Keywords:
rock fracture, semi-circular bending, propagation path, fracture characteristics, 3-D crackPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

