Investigation of Cutting Rock by TBM Hob using a SPG Method
Abstract
TBM (tunnel boring machine) hob is the core component of the TBM for rock cutting, whose cutting performance can directly determine the overall tunneling efficiency of the TBM. The understanding of cutting rock caused by TBM hobs is still not enough due to the complex contact features between the TBM hob and rock. To study the dynamic cutting process of the TBM hobs deeply, the rock cutting numerical model of the TBM hob is built based on the SPG (smooth particle Galerkin) method, the influence of hob penetration and hob spacing on rock breaking dynamic process, rock cutting forces and specific energy consumption are investigated. The results indicate that the dynamic process of sequential cutting of TBM hobs can be simulated well, and the rock breaking patterns caused by TBM hobs can be reflected with the SPG method. It also shows that the cutting forces of the hob are positively correlated with the hob penetration and hob spacing. For a given hob penetration, there exists an optimum hob spacing to acquire the highest rock cutting efficiency. The hob penetrations of 5, 7, 9, and 11 mm correspond to the optimum hob spacing of 60, 80, 90, and 100 mm respectively. Finally, the simulated results based on the SPG method are verified by comparing the experimental results and the CSM model. This study can provide a new method for simulating the rock cutting dynamic process of the TBM hobs.
Keywords:
TBM hob, SPG, hob penetration, hob spacingPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

