Numerical Investigation for the Bearing Performance of the Segmental Joint with Elastic Gasket
Abstract
Detailed three-dimensional numerical models considering concrete indentation, bolts, elastic gasket (EG) and sealing gasket (SG) are established for the segmental joint with gaskets, and the load tests of the joints with EG and without EG are simulated and compared. The results reveal that the bearing performance of the joint with EG is very complex. In sagging moment scenarios, it can be divided into four stages by three key points “EG starts to open”, “joint external edge starts to contact” and “EG fully opened”. In hogging moment scenarios, it can be divided into three stages by two key points “SG opened” and “EG starts to open”. The EG has a significant effect on the joint bearing performance. It can soften the joint, which leads to the result that the average bending stiffness and ultimate bearing capacity of the joint with EG are evidently smaller and weaker than those of the joint without EG. With decreasing the joint axial force, this softening effect tends to be more obvious. Besides, for the two joints, the ultimate states of the joints subject to the bending moments are both that the concrete at the joint edges yields firstly, and it is necessary to protect or strengthen the corresponding concrete.
Keywords:
shield water conveyance tunnel, segmental joint, bearing performance, elastic gasket, finite element modelPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

