Influence of Size and Orientation of 3D Printed Fiber on Mechanical Properties under Bending Stress
Abstract
The principle of FFF/FDM (Fused Filament Fabrication/Fused Deposition Modeling) 3D printing technology is the melting and application of a continuous fiber made of thermoplastic material, according to predefined routes on the substrate. A layer is created on which other layers are placed until the object is finished. It is the orientation of these fibers that greatly affects the resulting mechanical properties. Therefore, the printed object behaves orthotropic. The material does not blend perfectly or evenly between the individual fibers, which is why the resulting strength is limited by adhesion. Within the fibers themselves, it is also its dimension that affects the size of the contact surface and therefore the effect of adhesion. This contribution aims to compare the effect of fiber size in a given direction and its rotation in 3-point bending according to the standard ČSN EN ISO 178. The maximum bending load force was obtained and the bending stress and modulus of elasticity were determined. The influence of layer cohesion on the failure of the specimens is compared. One of the other important studied aspects for the effective production is the printing time of each specimen.
Keywords:
3D printing, FFF, FDM, PETG, bending, nozzlePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

