Studying the Failure Behavior of Cement-fiber-treated Sand under Triaxial Direct Tension Tests
Abstract
The main goal of this research is to study the failure behavior of cement-fiber-treated sand under triaxial direct tension condition tests. Thus, a new loading system and triaxial cell was designed and built for tensile loading. Samples were prepared with content cement of 3 and 5% (dry wt.) of the sand, while two types of polypropylene fibers 0.024 m in length and 23 μm and 300 μm thick were added at 0.0% and 0.5% (dry wt.) of the sand and cement mixture. After a seven-day curing period, the samples were loaded under triaxial direct tension tests under confining pressures of 100, 200, and 300 kpa in drained conditions. Stress-strain behavior, changes in volume and energy absorbed by cement-fiber reinforced sand were measured and compared with the results of other studies. Adding fibers resulted in reduced peak deviatoric stress and increased residual deviatoric stresses of the cement-fiber reinforced sand, with changes from brittle to ductile behavior. The initial stiffness and stiffness at 50% maximum tensile stress of the samples is decreased with the addition of fibers and with an increase in fiber diameter, the reduction rate of this stiffness is more evident. The absorbed energy for fibers with a thickness of 23 μm is less than fibers with a thickness of 300 μm. The effect of adding fibers to strength parameters showed that the cohesion intercept decreases, while the internal friction angle increases.
Keywords:
cement-treated sand, artificial fibers, triaxial direct tension, strength parametersPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

