Experimental Study of Axially Loaded Pile Group Near a Sloping Ground
Abstract
Understanding the axial loading response of pile group located near the crest of the slope is of practical value to structural design. In this paper, a large-scale test setup (1.8 m × 0.90 m × 0.90 m) has been developed to investigate the response of pile group (2 × 2) located near the crest of the slope under axial loading. This paper presents a series of physical modelling tests performed to investigate the effects of slope angles, distance of the pile group from the slope crest, embedment length of the pile group and pile diameter on the axial loading response of pile groups. The results show that the response of pile group located near the crest of the slope approaches to the level ground condition with increasing edge distance from slope crest. In addition, the horizontal displacement of pile group towards the slope face increases with decreasing distance of pile group from the slope crest or embedded length of piles or with increasing slope angle. Furthermore, increasing pile diameter results in a low increase in the horizontal displacement for edge distances less than 3 dp (dp = pile diameter). However, the horizontal displacement is almost independent of pile diameter at edge distances greater than 3 dp. Higher embedded length results in the response of pile group approaches to the response of pile group located on the level ground at a shorter edge distance from the slope crest.
Keywords:
pile group, slope, sand, physical modeling, axial loadPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

