The Influence of the Curing Conditions on the Behavior of Jute Fibers Reinforced Concrete Cylinders
Abstract
This paper presents an innovative method of reinforcement of concrete based on the use of the Jute fibers composites. These renewable raw bioresource fibers are available at a low cost. Moreover, they can be compared to Glass Fiber-Reinforced Polymer (GFRP) by enhancing the resistance of Jute Fiber-Reinforced Polymer (JFRP), while improving the compatibility between the fiber and the resin. For that purpose, this paper presents an experimental study that evaluates the influence of the curing conditions (time and temperature) on the behavior of JFRP laminates and concrete members strengthened by JFRP. The curing conditions at 30 °C for 2h 30min and at 50 °C for 1 h were the only two parameters studied and determined on the basis of Sikadur 330 properties and preliminary tests. Through the experimental tests, the maximum load capacity and observed failure modes are investigated. The results indicated that the curing at 30 °C for 2h 30min is the optimum curing condition. In addition, a low difference in the maximum load capacity was noted in the case of 50 °C. As to the failure modes, all the specimens cured with additional heat before being left under room conditions, have shown the ductile mode failure, especially in the case of specimens cured at 30 °C during 2h 30min. The analytical model conducted in this paper predicts the elastic modulus depending on temperature. The obtained results and proposed model can be used as input parameters in the analysis and design of externally strengthened members with Jute FRP composites.
Keywords:
JFRP composites, epoxy resin, reinforcement, curing conditions, concretePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

