Numerical Evaluation of Bond Behavior of Ribbed Steel Bars or Seven-wire Strands Embedded in Lightweight Concrete
Abstract
The bond-slip relationship between concrete and steel is significant in evaluating the nonlinear behavior of reinforced concrete structures. The force transmitted by the bond in reinforced concrete structures was studied numerically in high-strength, lightweight concrete with ribbed reinforcing steel bar or seven-wire strand, using ATENA 3D software. The first part of the study was a validation of the model based on the actual results of standardized pull-out tests using the software. Subsequently, the bond behavior was studied, where a four-point static bending test was modeled based on the real bond-slip relationship of the pull-out test. It was deduced that the ATENA 3D software can simulate the experimental tests and provide meaningful results. In addition, inferred from the numerical modeling, the maximum crack width and the mid-span deflection of the reinforced concrete beam increased when the bond stress between the concrete and the reinforcing steel bars was decreased. When a high amount of reinforcement (two strands) was used, concrete failure occurred before the strands yielded. However, further increase of the bond stress also decreased the maximum crack width and mid-span deflection. The failure occurred due to the increase in the strand yielding point by using one strand as a reinforcement of the beam.
Keywords:
numerical analysis, pull-out test, four-point static bending test, steel-concrete bond, seven-wire strand, ribbed steel bar, lightweight concretePublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

