Effects of Out-of-plane Brace-to-chord Angle on Multiplane CHS X-joints Behavior Under Brace Compression
Abstract
Multiplanar CHS X-joints, different from the common uniplanar CHS X-joints, usually with a relative small out-of-plane brace-to-chord angle (OPBCA) for appealing architectural appearance in the single layered lattice structures. In order to study the effects of OPBCA on the static behavior of circular hollow section (CHS) X-joints under brace axial compression, experimental tests and numerical parametric study on the ultimate capacity and load transfer pattern of the CHS X-joints were carried out. The numerical analysis results had good consistent with experimental tests in terms of the capacity and fail mode of the X- joints. OPBCA changes the load transfer pattern to more load at the up saddle point from the same load at the up and bottom saddles in uniplanar X-joints, and more obvious for the X-joints with lager OPBCA. OPBCA is also unfavorable to the capacity, especially the X-joints with relative large brace-to-chord diameter ratio and in-plane brace-to-chord angle. Then an equation considering the OPBCA influence factor, extended the capacity prediction formulae of uniplanar X-joints in the current specifications to the multiplanar X-joints, is also established; and the equation has been validated favorably.
Keywords:
CHS X-joints, out-of-plane brace-to-chord angle (OPBCA), load transfer pattern, ultimate capacity, OPBCA influence factorPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

