Establishment of Coal-rock Constitutive Models for Numerical Simulation of Coal-rock Cutting by Conical Picks
Abstract
One of the key points in numerical simulation of coal-rock cutting by conical picks is to select a proper coal-rock constitutive model. In order to find a reasonable coal-rock constitutive model, a uniaxial compression test was conducted to obtain the constitutive model. The several stages for linear elastic deformation and creep, plastic yielding, hardening, and finally brittle cracking of the constitutive units were studied, and the coal-rock constitutive model was established. As a result, the coal-rock cutting by one conical pick or two conical picks was simulated and the results were compared with coal-rock cutting experiment on a Coal-rock Cutting Machine. According to the simulation and experimental results, it is believed that the numerical simulation can reveal coal-rock crushing process. And the total error rate of coal-rock cutting by one conical pick between the simulation and experiment is 8.5%. The maximum deviation of coal-rock cutting by two conical picks between the simulation and experiment is 9.8%. All simulation values are within a reasonable range. The comparison indicates that the coal-rock constitutive model should better be defined considering the coal-rock crushing process by conical picks.
Keywords:
coal-rock constitutive model, conical pick, Weibull Distribution, coal-rock cutting, error analysisPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.

