Enhancing Thermal Simulations for Prototype Molds
Abstract
Our goal was the thermal analysis of epoxy acrylate-based prototype molds with numerical simulations, and to compare and analyze the measured values and calculated results. The difference between the thermal calculations and the measured values is significant; the actual temperature of the mold is higher than the calculated values. Based on the numerical simulations, we found that in the case of epoxy acrylate-based mold inserts, temperature results can be made significantly more accurate by changing the heat transfer coefficient between the surface of the mold insert and the melt. We proved that in the case of small-series epoxy acrylate-based molds, the temperature dependence of the thermal properties of the mold material, and the temperature and pressure dependence of the heat transfer coefficient need to be taken into account for accurate temperature results. We proved that the heat transfer coefficient between the mold surface and the melt is considerably lower than in the case of metal molds, due to lower cavity pressure and a lower temperature difference between the mold surface and the melt.
Keywords:
injection molding, conformal cooling, prototype molds, injection molding simulation, thermal analysisPublished Online
How to Cite
Issue
Section
License
- Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.
- Authors are able to enter into separate, additional contractual arrangements for the non-exclusive distribution of the journal's published version of the work (e.g., post it to an institutional repository or publish it in a book), with an acknowledgement of its initial publication in this journal.
- Authors are permitted and encouraged to post their work online (e.g., in institutional repositories or on their website) prior to and during the submission process, as it can lead to productive exchanges, as well as earlier and greater citation of published work (see The Effect of Open Access). As soon as the paper is accepted, finally submitted and edited, the paper will appear in the "OnlineFirst" page of the journal, thus from this point no other internet-based publication is necessary.
